Configuration of the data for shop floor data collection on Prinect CP2000 Center / Prinect Press Center

The attributes listed here are only required by Prinect CP2000 Center / Prinect Press Center. If you are sure that you will only assign these operations (PDC messages) to Data Terminal devices, you do not need to enter anything here. However, the operation will then not be transmitted to the Prinect CP2000 Center during synchronization (Synchronization of the PDC configuration with the press).

device_configuration_bde_13.png

 

Legacy ID

This legacy ID is a unique ID for the Prinect CP2000 Center / Prinect Press Center which is trans­ferred via the Workplace Interface. This legacy ID may be assigned only once (see figure above).

If you do not know whether your new legacy ID has already been assigned, you have to close the win­dow and then sort the list of all operations by the "Legacy ID" column. You can tell from the sorted list whether your new legacy ID has already been assigned.

Legacy type

The default value is the entry "Id". The other entries should not be used.