Loading the 'Marks' Resource to the Job

The marks are also loaded indirectly with the "Plate Templates" resource. On the plate template, the marks set refer to the plate, paper or subject.

This is where you load the "Marks" resource to the job:

•"Marks" step > enable "Automatically Placed Print Control Marks". The cut marks and folding sheet labels that are set relate to the pages or folding sheet, and the folding and collating marks to the folding sheet. The marks are selected in the preferences.

•Folding Sheet Inspector > "Marks" / "Marks Resources"

•Press Sheet Inspector > "Marks" / "Marks Resources"

•Page Inspector > "Marks" / "Marks Resources"

•Direct assignment by dragging and dropping the resource from the "Marks Resources" tab of the inspectors named above.