Trap_editor-69

Single trap selection

Click on the object whose trap is to be selected. The adjacent trap is automatically selected.

If the object has several traps, use the (Next) or (Previous) buttons to select the desired trap.

Note: You can select a single trap as follows:
Click the first object. Holding down the Alt key, click the second object. The trap between these two objects is automatically selected.

Note: The selected traps are highlighted if "Selected" is enabled in "Highlight".

Several traps selection

If you wish to select several traps, you must first select the relevant objects.

The Trap Selection setting determines which traps are selected:

•All Traps
All the traps of the selected objects are selected (for example, to jointly change their trap width). Trap color and trap direction cannot be changed in this mode.

•Same Pairs
All traps of objects with the same color pairing as the objects in "Focus" are selected from the group of selected objects (for example, for a joint reduction of the trap color).

•Single
Only one single trap is selected from the selected objects.

Back to Working with the Trap Editor.