In "Administration > System", you can make the following settings and receive information:
•License Server
"License Server" shows the computer name of the License Server that makes the licenses for Prinect Renderer available. Normally, the License Server is defined during installation of the Prinect Renderer software. However, if the License Server is to be located on a different computer or if the computer name of the License Server is changed, a modify installation of the Prinect Renderer WebUI setup is required. You should change the computer name before you disable the old License Server. After you modify the License Server, exit the Prinect Renderer services with "Service Control". Afterwards, make sure that the new License Server is running and can be reached in the network and that the required licenses are assigned to the Prinect Renderer computer (in the License Manager). After that, restart the Prinect Renderer services.
•Temporary Folder
Prinect Renderer uses the temporary folder to buffer data that are created during job processing.
•Configuration spool directory
All the job data created temporarily during processing are buffered in the configuration spool directory. This buffer action is known as "spooling". The spool directory contains the data of all the jobs in the job list. This includes the data of finished jobs that are not yet removed from the job list. Because the Job files can be very large, the spool directory should be located on a drive of the Prinect Renderer PC that has enough available disk space. You can check the available disk space of each of the Prinect Renderer PC drives in the drive monitor. See Drive Monitor.
Options
•Pause Jobs after restarting the server
If this option is set, all jobs that are still to be processed are set to "paused" when you reboot the computer.
•Check whether there is sufficient material when starting jobs
This is where you specify for platesetters whether the material stock is to be checked before starting jobs.
•Always ask
If this option is enabled, a dialog where you can define the depot folder appears each time a job is to be stored.
When you disable this option, you can specify the depot directory for jobs in which a depot directory has not been specified. By default, the Default Depot Directory is used. See Depot Directory.
•Pause job before reprint
If this option is set, all jobs that are still to be processed are set to "paused" when you trigger a repeat output. These settings apply to all devices.