Sequence Templates - Plate Output

"ImpositionOutput" Sequence Template

The "ImpositionOutput" sequence lets you control the output of surfaces or parts of the surfaces to the imagesetter.

Note: The settings that are possible in each parameter group can vary depending on your imagesetter. As a result, some parameters may be shown but they cannot be selected. In such a case, the device selected doesn't support these parameters.

Depending upon the configuration of your Prinect software, you can perform the following steps in the ImpositionOutput sequence:

•"Accept approved Surfaces only" Option

•"Color Usage" options

•"Color Conversion" option

•"Marks Replacement" Option

•"InRIP Trapping" Option

•"Imposition" option

•"Rendering" Option

•"Calibration" Option

•"Screening" option

•"Sheet Preview Generation" option

•"Thumbnail Generation" option

•"Halftone Soft Proof" Option

•"File Output" Option

•"HDM:PaperStretchCompensation" Option

•"Image Setting" Option

•"Plate Approval" Option

•"Destination" Option