Create Output Condition

Create Output Condition

Prinect Color Center guides you through several steps when creating a new output condition.

Depending on whether you are using a Labelfire or a Primefire, the procedure is different in some steps.

Labelfire

With the Labelfire, the procedure is as follows:

1.Preparation

2.Ink Limit

3.Printability

4.MNC (Missing Nozzle Compensation)

5.DUC (Density Compensation)

6.Calibration

7.ICC Profile

8.Substrate Check

You should run through these steps in this order. However, "Density Compensation" and "Nozzle Compensation" are independent of the other steps and can be done ahead of the other steps, if nec­essary.

Primefire

With the Primefire, the steps are basically identical, but in a different order. In this Help, we describe the steps in the order applicable to the Labelfire. For this reason, a link leading you to the next Prime­fire step was added at the end of each step.

For the Primefire, there are the following steps:

1.Preparation  

2.Dryer

3.DUC (Density Compensation)

4.Geometry

5.Ink Limit (only for expert users)

6.Calibration  

7.ICC Profile  

8.Substrate Check